澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票

当前位置:首页-澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票 > 澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票通风空调管道质量通病的防治

发布人:http://olivierbernier.com   发布时间:2021-08-11 16:29:39

保温质量通病主要表现为胶水涂刷不均匀,保温材料粘接不严密,保温材料的厚度选用不正确以及外观型式不统一,型式不美观等。在施工中有如下几个主要质量问题:

The common problems of thermal insulation quality mainly include uneven glue brushing, loose bonding of thermal insulation materials, incorrect selection of thickness of thermal insulation materials, inconsistent appearance type, unsightly type, etc. There are several main quality problems during construction:

(1)保温层与木托粘接不严密。施工中,因工人保温层长度测量不准确,工人施工时常将保温材料拉长后粘接。由于材料本身有弹性,拉伸后即会收缩,时间长了,就出现了保温材料与木托粘接处开胶的现象,这是保温中更常见的质量问题之—。

(1) The bonding between the insulation layer and the wooden support is not tight. During construction, due to the inaccurate measurement of workers' insulation layer length, workers often stretch the insulation materials and then bond them. Due to the elasticity of the material itself, it will shrink after stretching. After a long time, the adhesive between the thermal insulation material and the wooden support will open, which is one of the most common quality problems in thermal insulation.

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票防治措施:在下料和粘接过程中不准拉伸材料,同时要求在木托两侧和保温材料截面上都要涂刷胶水,胶水涂刷的要均匀饱满;木托要选用规则的,如果木托断裂成数块,就要换掉 ,防止因冷桥产生结露现象。

Prevention measures: it is not allowed to stretch materials during blanking and bonding. At the same time, glue shall be painted on both sides of the wooden support and on the section of the thermal insulation material, and the glue shall be painted evenly and fully; The wooden support shall be regular. If the wooden support is broken into several pieces, it shall be replaced to prevent condensation due to the cold bridge.

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票(2)保温材料之间粘接不严密。保温材料之间的粘接比较常见,特别是在水平管上方和立管的侧面保温材料的粘接缝较长,很容易出现粘接不牢的现象。这主要是材料在切割过程中截面不平整、胶水涂刷不均匀造成的,这也是保温中更常见的质量问题之一。

(2) The bonding between thermal insulation materials is not tight. The bonding between thermal insulation materials is common, especially above the horizontal pipe and on the side of the riser. The bonding joint of thermal insulation materials is long, which is prone to loose bonding. This is mainly caused by the uneven section and uneven glue brushing during the cutting process, which is also one of the most common quality problems in thermal insulation.

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票防治措施:要求施工人员在下料的过程中要使用直尺,不能徒手下料,涂刷胶水时要求均匀,粘接时要从一侧开始逐步向另一侧用力挤压,保证材料的切割面都能受力粘接牢固。

Prevention and control measures: the construction personnel are required to use a ruler in the process of blanking, and the blanking shall not be done by hand. The glue shall be applied evenly, and the bonding shall be squeezed gradually from one side to the other side, so as to ensure that the cutting surface of the material can be stressed and bonded firmly.

(3)弯头处开胶。管道保温时一般要求把保温层接缝放在管道上方,而在管道的弯头上方经常出现保温层开裂现象,致使局部保温层过薄,造成凝结水结露。

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票(3) Glue shall be opened at the elbow. During pipeline insulation, it is generally required to place the joint of the insulation layer above the pipeline, and the insulation layer cracking often occurs above the elbow of the pipeline, resulting in local insulation layer being too thin and condensate condensation.

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票防治措施:要求施工人员在做弯头保温时不能只根据估计的尺寸下料,要用软皮尺精确量取尺寸;所下料的截面要平整;在管道弯头局部受力大的地方多涂抹胶水。

Prevention and control measures: the construction personnel are required not to cut materials only according to the estimated size when making elbow insulation, but to accurately measure the size with a soft leather ruler; The cut section shall be flat; Apply more glue where the local stress of the pipe elbow is large.

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票对弯头保温时,尽量采用直接弯管保温,即保温层粘接缝顺着管道方向,而不采用切割马蹄型分多次粘接来找补弧度的方法。这样可省去大量的人力时间和材料,还能保证保温质量,同时外观上也较后者美观。

For elbow insulation, direct elbow insulation shall be adopted as far as possible, that is, the bonding joint of the insulation layer shall follow the direction of the pipeline, rather than the method of cutting horseshoe type and multiple bonding to repair the radian. In this way, a lot of manpower, time and materials can be saved, the insulation quality can be guaranteed, and the appearance is more beautiful than the latter.

20170427487014.jpg

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票(4)穿墙套管歪斜。实际施工容易出现管道穿墙处的套管放置偏心或偏出墙体,致使保温层不能穿过墙体,起不到保温的作用。

(4) The through wall casing is skewed. In actual construction, it is easy to place the casing at the place where the pipeline passes through the wall eccentric or deviates from the wall, so that the thermal insulation layer cannot pass through the wall and cannot play the role of thermal insulation.

防治措施 :套管一般是直接采用施工中的管道切割制作,根据墙体厚度和抹灰厚度定出套管长度,在墙体施工前用多根楔型木条把套管支撑起来,固定在管道上,塞木条时要保证套管与管道同心。保温施工时把木条拆下来,再将保温层穿过套管。

Prevention and control measures: the casing is generally cut and made directly by the pipeline in construction. The length of the casing is determined according to the wall thickness and plastering thickness. Before wall construction, the casing is supported and fixed on the pipeline with multiple wedge-shaped wooden strips. When plugging the wooden strips, ensure that the casing is concentric with the pipeline. During insulation construction, remove the wooden strip, and then pass the insulation layer through the casing.

(5)成品被破坏。橡塑保温施工完毕后,靠近人行通道的保温管道,容易被沉重和尖锐的物体磕碰、刮破。

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票(5) The finished product is damaged. After the rubber and plastic insulation construction, the insulation pipeline close to the pedestrian passage is easy to be knocked and scratched by heavy and sharp objects.

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票防治措施 :在明装的地方采用纸箱或厚的塑料布包裹严密,用铁丝捆绑结实,施工中可以利用橡塑材料或风机盘管的包装箱。保护层要超过普通人手所能够到的高度。在明装的新风机房和明装管道井中的保温要尽量推迟到其它工种施工完毕后再施工,争取一次做到位。

澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票Prevention and control measures: the exposed places shall be tightly wrapped with cartons or thick plastic cloth and firmly bound with iron wires. Rubber and plastic materials or packing boxes of fan coil units can be used in construction. The protective layer should be higher than ordinary hands can reach. The thermal insulation in the exposed fresh air fan room and exposed duct shaft shall be postponed to the construction of other types of work as far as possible, and strive to be in place at one time.

好的产品成就好的服务,好的企业成就好的产品, 济南通风管道坚持为客户提供优质的服务,详情请继续关注我们的网站:http://olivierbernier.com

Good products make good services, and good enterprises make good products. Jinan ventilation duct insists on providing customers with high-quality services. Please continue to pay attention to our website for details: http://olivierbernier.com


上一篇:通风管道的材料如何进行分类?
下一篇:清洗通风管道这些方法要用上!

网站首页 关于我们 澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票 澳门金牛版1877-澳门彩1877cc-1877彩票购彩大厅-1877.cc彩票 工程案例 在线留言 联系我们

今日开马网站-105333香港赛马-hkjc香港赛马主页投注-香港神算子97567-香港神算子四肖